Netcomm NB6PLUS4WN User Manual download pdf (Page 166)

NB6, NB6W, NB6Plus4, NB6Plus4W, NB6Plus4Wn User Guide YML854Rev1

166 www.netcomm.com.au

APPENDIX D: LEGAL & REGULATORY INFORMATION

This manual is copyright. Apart from any fair dealing for the purposes of private study, research, criticism or review, as permitted under the

Copyright Act, no part may be reproduced, stored in a retrieval system or transmitted in any form, by any means, be it electronic, mechanical,

recording or otherwise, without the prior written permission of NetComm Limited. NetComm Limited accepts no liability or responsibility, for

consequences arising from the use of this product.

NetComm Limited reserves the right to change the speciﬁcations and operating details of this product without notice.

NetComm is a registered trademark of NetComm Limited.

All other trademarks are acknowledged the property of their respective owners.

Customer Information

ACA (Australian Communications Authority) requires you to be aware of the following information and warnings:

(1) This unit shall be connected to the Telecommunication Network through a line cord which meets the requirements of the ACA TS008

Standard.

(2) This equipment has been tested and found to comply with the Standards for C-Tick and or A-Tick as set by the ACA . These standards are

designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can

radiate radio noise and, if not installed and used in accordance with the instructions detailed within this manual, may cause interference to

radio communications. However, there is no guarantee that interference will not occur with the installation of this product in your home or

ofﬁce. If this equipment does cause some degree of interference to radio or television reception, which can be determined by turning the

equipment off and on, we encourage the user to try to correct the interference by one or more of the following measures:

• Change the direction or relocate the receiving antenna.

• Increase the separation between this equipment and the receiver.

• Connect the equipment to an alternate power outlet on a different power circuit from that to which the receiver/TV is connected.

• Consult an experienced radio/TV technician for help.

(3) The power supply that is provided with this unit is only intended for use with this product. Do not use this power supply with any other

product or do not use any other power supply that is not approved for use with this product by NetComm. Failure to do so may cause damage

to this product, ﬁre or result in personal injury.

1 2 ... 161 162 163 164 165 166 167 168 169 170

No comments

Netcomm NB6PLUS4WN User Manual Page 166