Netcomm NB1300 User Manual download pdf (Page 10)

www.netcomm.com.au Rev. 1- YML672

Page 10 NB1300_2 ADSL Modem

Overview Section

Factory Defaults

The following table lists the Factory Defaults of your NB1300 ADSL Modem:

Field Setting Details

LAN IP address: 192.168.1.1

LAN Subnet Mask: 255.255.255.0

DHCP Server: Enabled

User Name: admin

Password: password

Main Function: Router (Bridge Disabled)

WAN connection type: PPPoE LLC

VPI: 8

VCI: 35

Note: These defaults may change with firmware updates and factory changes, please

consult the NetComm website to check for the latest defaults.

Resetting to factory defaults

If you forget your passwords, lock out HTTP or FTP access or simply can’t remember what IP

address you have set the NB1300 on you will probably need to perform a factory defaults reset.

To perform a factory defaults reset you must have physical access to the unit then follow these

steps;

1. Make sure the NB1300 is powered on and the RDY light is flashing.

2. Locate the Reset button hole on the back of the unit.

3. Gently press in and hold the button for 5 seconds with a suitably thin appliance (E.g.

straightened paper clip) seconds after release the RDY light will turn off.

4. Watch the RDY light and wait for it to stabilise and start pulsing again (in approximately 1

minute.

Note: Do not switch off or press reset again until the NB1300 has completed its reset and

the RDY light is flashing.

5. Your router should now be set to factory defaults (192.168.1.1, ‘admin’ & ‘password’)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 83 84

No comments

Netcomm NB1300 User Manual Page 10