Netcomm NB1300 User Manual download pdf (Page 33)

Rev. 1 - YML672 www.netcomm.com.au

NB1300_2 ADSL Modem Page 33

Advanced

Advanced Configuration for your NB1300

How to make changes

The NB1300 utilises a Web based interface for configuration, this means that you do not need to

load drivers (unless using USB) and configuration is always performed via a Web browser (such

as Internet Explorer or Netscape Navigator).

For each configuration page there is a Submit button to store the changes for that page before

you move on to the next page. Once you have made all your required changes you must click the

Save Settings and Reboot button.

Clicking this button will permanently store all your changes and implement them by performing

a reboot. Please wait upto 30 seconds for your router to reboot and resynchronize the ADSL

link (Showtime). The Reboot process is complete when the RDY light starts pulsing steadily

again.

Note: DO NOT power the unit off or press the reset button again during the reboot process

Multiple Virtual Circuits

The NB1300 is capable of being configured to maintain multiple virtual circuits – that is multiple

routed connections or PPP sessions down the same ADSL copper cable. Most ADSL

connections will only support one PPP session please confirm your line’s / accounts capabilities

with your ISP. All configurations made in the one-page setup are made to Virtual Circuit Zero

(VC0). You can configure the other VCs individually by opening the Advanced WAN page and

selecting which VC you want to edit at the bottom of the page then pressing the Submit button.

All fields on that page will be presented in terms of the Virtual Circuit number just chosen.

USB or Ethernet?

The NB1300 can be connected via a USB cable or an Ethernet cable or both. The reason for this

is that the USB connection is simply an ehternet simulation, as far as your computer is

concerned the USB connection is an Ethernet connection, hence DHCP and other protocols will

work the same as for Ethernet.

1. After connecting all the ADSL Router cables,

powering on the ADSL Router, and launching a web

browser, such as Internet Explorer or Netscape

Navigator, browse to the address http://192.168.1.1.

2. Enter the correct user name and password to access

the Configuration tool. The default user name and

password are as below.

User Name : admin

Password : password

Note: You must click the Submit button on every page that you make changes on and

when you have made all your changes click the Save Setting and Reboot button

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 83 84

No comments

Netcomm NB1300 User Manual Page 33